Conventional k-space RPA#
The conventional method computes the response by a direct sum over band
transitions at each frequency. It is available for task = rpa. Use it to check
the space-time method, or to calculate on a grid without time nodes. The
equations and the cost are in docs/theory/rpa/conventional.md in the source
tree.
Input#
The option chi0_method selects the method of the response function:
Value |
Method |
|---|---|
|
|
|
Space-time method. The grid must have time nodes. |
|
Conventional method at the frequency nodes of the grid |
Only the minimax and evenspaced_tf grids have time nodes. The other grids,
such as GL, GC-I and GL-II, have frequency nodes only.
To use Gauss-Legendre quadrature on the positive imaginary-frequency axis:
task = rpa
tfgrids_type = GL
nfreq = 48
Increase nfreq until the correlation energy converges to the tolerance that
you need. For the H2O and Si test data, the change from 24 to 48 points is about
2.5e-7 Ha.
To compare the two methods with the same frequency quadrature, use a minimax grid in two calculations, one with each method:
task = rpa
tfgrids_type = minimax
nfreq = 16
chi0_method = conventional
The difference between the two energies then comes only from the space-time method, for example from the time grid and the time-to-frequency transform. For the H2O and Si test data on a 16-point minimax grid, the two energies agree to 1e-9 Ha.
In the C and C++ APIs, set chi0_method to LIBRPA_METHOD_CONVENTIONAL, and
tfgrids_type to the grid, for example LIBRPA_TFGRID_GAUSS_LEGENDRE.
Parallelization#
The method works with all parallel_routing values, and with builds without
LibRI. With atompair and libri, MPI ranks share the atom pairs. With rtau,
they share the q points. In a build without LibRI, set
use_scalapack_ecrpa = false with atompair, because the ScaLAPACK energy
routine needs LibRI. Otherwise the calculation stops at the start.
Requirements#
Supply the eigenvectors of all k points of the full SCF mesh. The mesh must contain -k for each k. The order of the k points can be arbitrary.
Use scalar or collinear-spin wave functions.
Keep
use_kpara_scf_eigvec,use_symmetry_rpaanduse_shrink_abfsat their default value,false.Use grids with strictly positive frequencies.
n_bands_chi0 and n_bands_exclude_chi0 apply to both bands of a transition.
Do not set a cutoff inside a degenerate multiplet: the retained states then
depend on the eigenvector gauge, and LibRPA can stop with a non-Hermitian
response error. The same error occurs for time-reversal-broken input and for a
mesh without -k.
GW and cRPA use the space-time method only. They stop at the start of the
calculation on a frequency-only grid or with chi0_method = conventional.
Head and wing replacement (replace_w_head) has not been validated with this
method.